Brake pads installation is a vital process of ensuring that you have a safe ride devoid of any accidents. Even if you have a mechanic to do the work, it is always good to know the basics of installing brake pads on your own.

STEP 1

Exposing the brake pads

  • Make sure the vehicle is cooled down -If the car had previously been driven, it may result to heating the pads. Working on hot pads can be tricky, and you ought to wait until the motor vehicle cools completely. Make sure the parts are safe to touch before you embark on the installation process.
  • Loosen the lug nuts -When loosening the lug nuts, use the lug wrench and the car’s jack. You should not loosen all your tires at once. Change the two front pads or the two back pads; this varies according to the make of your car and how the brakes wear. You can either start with the front or the back.

  • Set up the jack carefully –you should place the car jack carefully until you reach a comfortable position. You ought to put the blocks behind the other wheels to avert any movement.
  • Remove the wheels -After you are done loosening and removing the lug nuts, pull the tire out slowly. Gently clean the studs, rear mounting surface and rotor mounting surface with a wire brush. When you are done with this step, apply the anti-seize compound before you refit the wheel.
  • Remove the caliper bolts by use of the right size of ring spanner-The caliper will fit nicely over the brake rotor and it slows the wheel using hydraulic pressure.
  • Hang the caliper -Carefully hang the caliper with a small piece of wire so that it does not hang and insert pressure on the flexible brake hose.

STEP 2

Changing the pads

  • Remove the old pads– remove both pads; you only need to apply little force. Care should be taken not to spoil the calipers. If you want to get quality brake pads, you can get them from Gabriel Automotive. Get the pad that fully suits your preference and taste. Make sure you install the brake pads so that you reap the maximum benefits from them. Many people do not bother to recondition or even to replace them, but installing the brake pads the right way prevents brake noise and also uneven pad wear.
  • Put the new pads on –smear some anti-seize lubricant on the metal contact edges and at the back of the pads. Fix the new pads where the old ones were.
  • Check the brake fluid – check the level of the brake fluid: you can add some if need be.
  • Replace the caliper – Slide the caliper gradually back to the rotor. Tighten the bolts that put the caliper in its right place.
  • Put the wheel back and tighten the loose lug nuts – Tighten each lug nut before you lower the car.
  • Start the car –check to make sure the vehicle is in neutral or park. Pump the car for about 15-20 times.
  • Test the car– braking test ensures that your brakes are working in a perfect way.

Maintenance and repair of your motor vehicle is very essential. A Vehicle with a good brake system is safe on the road and, thus, the brakes ought to be serviced and reinstalled after some time. Gabriel’s Auto brake service strives to give you the above service and saves you the trouble.